5 Things You Must Do If You Want To Make Sure Wood Is Straight

5 Things You Must Do If You Want To Make Sure Wood Is Straight

Word Count:

275

Summary:

Twisted and unstraight wood is one of the most common causes for frustrations in the workshop. This hurdle can easily be overcome and it will make all the difference in the end result. It can be done in 5 easy steps.

Keywords:

furniture, woodworking, tools,woodfinish, wood

Article Body:

1. Make two lists of Wood.

Each 500mm long

45mm wide

25mm thick.

The lists needs to be completely straight and even. Make sure they are witout twigs in the material.

These lists of wood may become one of your most important tools in your workshop.

2. Position the lists

Lay the lists opposite of the direction of the wood in your piece. One at each end. This will provide you with two reference points.

3. Measure

Take a couple of steps back and aim. The two lists should appear parallel, if they do then the piece is straight. Congratulations! This is what you want. Unfortunately that is not always the case - If it`s not straight move on to step 4.

4. Mark it

If the wood is not straight take a pencile and mark where the wood is elevated. Then scrubb down. An important note though, do not remvoe too much at a time. better to go slowly then to end up having the hole piece renderd useless due to beeing in a hurry.

5. Re-check

The last and most important step is to re-check. Repeat step 3-5 until you are completely satisfied.

When it is straight mark the side so you know that side is straight turn the piece and do the hole process on the other side.

PS. If you truly want to build great furniture check out: http://www.build-classic-furniture.com

This is a "Shareware" Article

(what's that? read on...)

This article is shareware. Give this article away for free on your site, or include it as part of any paid package as long as the entire article is left intact including this notice. Copyright © 2006 Stian Kjellhov